Students can refer to the following Sample Paper ICSE Class 10 Technical Drawing Applications Set A with Answers provided below based on the latest syllabus and examination guidelines issued for ICSE Technical Drawing Applications. All specimen papers have been prepared covering all chapters given in ICSE Technical Drawing Applications book for Class 10. You should also refer to ICSE Class 10 Technical Drawing Applications Solutions.
Sample Paper ICSE Class 10 Technical Drawing Applications Set A with Answers
Subject: Technical Drawing Applications
Answer to this paper must be written on the paper provided separately.
You will not be allowed to write during the first 15 minutes.
This time is to be spent in reading the question paper.
You must attempt three question from Section A and two questions from Section B.
The time given at the head of this Paper is the time allowed for writing the answers.
Section A (48 marks)
(Attempt any 3 out of 5 question)
Question 1 Copy Figure 1 showing all construction lines clearly. [16]
Question 2 Construct a diagonal scale of R.F. = 1:500 to show Meters and decimetres and long enough to measure up to 80 meters. Measure the distance 54.5 meters[16]
Question 3 Refer to Figure 2. Draw the oblique view. [16]
Question 4
a) Construct an ELLIPSE using Arcs of circles method. [08]
Major axis = 140mm and Minor axis = 80mm
b) Draw a circle of radius 40mm and draw 3 equal circles inside it touching each other.[08]
Question 5
a) Draw the DEVELOPMENT of a cylinder. [06]
Show the calculations neatly. Given: Radius of the base = 21mm. Axis height = 60mm.
b) Draw FV and TV of a square prism of side 35mm and axis height 70mm is resting on its base edge on H.P. with axis inclined at 450 to H.P. perpendicular to V.P. and two sides of square prism are perpendicular to V.P. and parallel to V.P.
Section B (52 marks)
(Attempt any 2 out of 3 question)
Question 6 Copy Figure 3 showing all construction lines clearly. [26]
Question 7 Refer to Figure 4. Draw the following views. [26]
a) Sectional Front View. (along A-A)
b) Left hand side view.
c) Top View
Question 8 Refer to Figure 5 and draw. [26]
Front view, SSV, STV, Development and TSS.
